- DOT tests are for safety-sensitive employees regulated by a U.S. DOT agency. Everyone else is non-DOT.
- A DOT test follows 49 CFR Part 40 exactly, on the federal form, and always includes marijuana.
- The two must be kept completely separate. When one person needs both, the DOT test is done first.
Who needs a DOT test
DOT testing applies to employees who do safety-sensitive work regulated by an agency of the U.S. Department of Transportation. For most local fleets that agency is the Federal Motor Carrier Safety Administration, and the employees are drivers of commercial motor vehicles that require a commercial driver’s license.
Aviation, transit, rail, pipeline and maritime employers have their own DOT agency rules. All of them use the same testing procedures, which are set out in 49 CFR Part 40.
If you are not sure whether a job is covered, ask your consortium or third-party administrator, or check the rules of the DOT agency that regulates you. It is your decision as the employer, not the collector’s.
What makes a DOT test different
- The procedures in 49 CFR Part 40 are followed exactly. There is no room to adapt them.
- The collection is recorded on the Federal Drug Testing Custody and Control Form.
- The laboratory tests for the DOT 5-panel, which always includes marijuana (THC), whatever state law says.
- A Medical Review Officer reviews every result before it is reported.
- Results go only to your designated employer representative.
What a non-DOT test is
A non-DOT test is one your company chooses to run under its own written policy, within what state and local law allows. It is collected on the laboratory’s own form, and the panel can be different from the DOT panel.
In New York, state and city law limit when an employer may test for marijuana. Our separate guide covers those rules.
Keep the two apart
Federal rules say DOT tests must be completely separate from non-DOT tests in every respect. The federal form may not be used for a company test, and a company form may not be used for a DOT test.
When one person needs both kinds of test at the same visit, the DOT test takes priority: it is conducted and completed before the non-DOT test begins, and a separate specimen is collected for each.
A collection cannot be switched from one kind to the other once it has started. That is why we confirm which applies to each person when you book.
If you have both kinds of employee
Many employers do. Drivers who hold a commercial license are in the DOT program, while shop, warehouse and office staff are tested under company policy, if at all.
One on-site visit can cover both groups. Each person is collected on the correct form, and your donor list says which is which.
Official sources
- 49 CFR Part 40, DOT drug and alcohol testing procedures (eCFR)
- U.S. DOT Office of Drug and Alcohol Policy and Compliance
Last checked against these sources in November 2026. This guide is general information, not legal advice. Rules change and have exceptions that a short guide cannot cover, so check the official text or speak to an attorney before acting on it.